# In a nutshell, this configuration defines the configuration required to run
# NixOS on the Dell EMC EGW 5200 (often the config that NixOS put in
# hardware.nix by default).
{ config, lib, modulesPath, ... }:

{
  imports = [
    (modulesPath + "/installer/scan/not-detected.nix")
  ];

  boot.initrd.availableKernelModules = [
    "xhci_pci"
    "ahci"
    "usb_storage"
    "usbhid"
    "sd_mod"
  ];
  boot.initrd.kernelModules = [ ];
  boot.kernelModules = [ "kvm-intel" ];
  boot.extraModulePackages = [ ];
  boot.loader.systemd-boot.enable = true;
  boot.loader.efi.canTouchEfiVariables = true;

  fileSystems."/" = {
    device = "/dev/disk/by-label/NIXROOT";
    fsType = "ext4";
  };

  fileSystems."/boot" = {
    device = "/dev/disk/by-label/NIXBOOT";
    fsType = "vfat";
  };

  swapDevices = [ ];

  powerManagement.cpuFreqGovernor = lib.mkDefault "powersave";
  hardware.cpu.intel.updateMicrocode = lib.mkDefault config.hardware.enableRedistributableFirmware;

  # Needed for Tailscale subnet routing
  boot.kernel.sysctl."net.ipv4.ip_forward" = 1;
  networking.useDHCP = false;
  networking.interfaces.eno1.useDHCP = true;
  networking.interfaces.enp3s0.useDHCP = true;
  networking.interfaces.enp4s0.useDHCP = true;

  system.stateVersion = "21.11";
}