Nix has two relevant settings with regards to how your CPU cores will be utilized: and . This chapter will talk about what they are, how they interact, and their configuration trade-offs. Dictates how many separate derivations will be built at the same time. If you set this to zero, the local machine will do no builds. Nix will still substitute from binary caches, and build remotely if remote builders are configured. Suggests how many cores each derivation should use. Similar to make -j. The setting determines the value of NIX_BUILD_CORES. NIX_BUILD_CORES is equal to , unless equals 0, in which case NIX_BUILD_CORES will be the total number of cores in the system. The total number of consumed cores is a simple multiplication, * NIX_BUILD_CORES. The balance on how to set these two independent variables depends upon each builder's workload and hardware. Here are a few example scenarios on a machine with 24 cores:

Balancing 24 Build Cores

		NIX_BUILD_CORES	Maximum Processes	Result
1	24	24	24	One derivation will be built at a time, each one can use 24 cores. Undersold if a job can’t use 24 cores.
4	6	6	24	Four derivations will be built at once, each given access to six cores.
12	6	6	72	12 derivations will be built at once, each given access to six cores. This configuration is over-sold. If all 12 derivations being built simultaneously try to use all six cores, the machine's performance will be degraded due to extensive context switching between the 12 builds.
24	1	1	24	24 derivations can build at the same time, each using a single core. Never oversold, but derivations which require many cores will be very slow to compile.
24	0	24	576	24 derivations can build at the same time, each using all the available cores of the machine. Very likely to be oversold, and very likely to suffer context switches.

It is up to the derivations' build script to respect host's requested cores-per-build by following the value of the NIX_BUILD_CORES environment variable.